Ability to specify client id used for push subscriptions, and to specify maximum number of times to retry a request has replaced it.Ĭonnecting to a ScreenLogic Protocol Adapter Changed in v0.8.0: Support for passing connection info to gateway constructor is fully deprecated and has been removed.Connection info should be passed to async_connect() instead. Changed in v0.7.0: Passing adapter connection info when instantiating the gateway is deprecated and will be removed in a future release.Changed in v0.5.0: Instantiating the gateway no longer automatically connects to the protocol adapter or performs an initial update.from screenlogicpy import ScreenLogicGateway gateway = ScreenLogicGateway () The ScreenLogicGateway class is the primary interface. This will be the last version to support Python 3.8. New in v0.8.0: Support for Python 3.8 and 3.9 is being phased out across future releases.Relevant methods now require the async/ await syntax. Changed in v0.5.0: The screenlogicpy library has moved over to using asyncio for all network I/O.The screenlogicpy package can be installed from PyPI using pip. in the lower right of the page you showed.Screenlogicpy is an interface for Pentair ScreenLogic connected pool controllers over IP via python using asyncio. To see the setup page I showed above you have to go into the 'Configure ScreenLogic' tab. Let me know if that does not make sense.' At 1 pm the speed increase to 2000 RPM and at 2 pm the pump goes back to running at 1200 RPM until 8 pm. At 10 am the pump goes back to running at 1200 RPM. At 9 am the pump increases speed to 1500 RPM. Scheduled from 9 am until 10 am (You can name it anything you like.)įeature Circuit #2 called Skim High. Say 1200 RPM.įeature Circuit #1 called Skim low. at the lowest speed that will run the SWCG. Say you want to run from 8 am until 8 pm. Why would you want to run the pump and not make chlorine. The Key is to always have the Pool or Spa Circuit on for the entire time you want the pump running. This relay only closes when in the Pool or Spa mode. Your SWCG's transformer is wired to the load side of the Pump/Filter relay. 'Your system is working just like it was designed. I just posted the following in another thread, but it should work for you also.

Pentair screenlogic software download